Filter
Top Products
Introduction
1–4 975-0187-01-01
Information Centers of the XC Series
Remote Display
This section describes the parts of the remote display of the XC Series. The remote
display can be rotated 180°, or it can be removed and remotely mounted up to 20 m
(65 ft) from the XC Series for convenience. Figure 1-2 shows the remote display.
A “press and hold” action on the remote display means that the button must be held
down for more than 2 seconds in order to send the instruction. A “press” action on
the remote display means that the button must be pressed and released before 2
seconds have elapsed.
Figure 1-2
XC Series Remote Display
Item Description
1
ON/STANDBY push button
• Press to turn on or disable the charger while AC power is connected
• Press and hold to apply selection when in setup or equalization mode
• Press to show battery bank voltages when AC is disconnected
2 Battery bank indicator lights
• Illuminate to show which bank has been selected for setup or status display
• Illuminate during a fault or warning to show which bank has the fault or warning, or
illuminate all three if the charger itself has the fault or warning
1
2 3 4 5
7
6
XC_Charger_Owner.book Page 4 Friday, August 12, 2005 3:23 PM