A SERVICE OF

logo

MENU
2
DEF
F2F2
DONE
2
DEF
MENU
4
JKL
2
DEF
F2F2
DONE
By default, the backlight in FiberMeter series optical power meters is set to be always ON. To save power, the
backlight status may be set to OFF by following these steps below:
FROM CERTIFICATION METER
1) Press to activate the MAIN MENU.
2) Press to activate the METER CONFIG MENU.
3) Press to activate the USER PREFERENCES menu.
4) Press to set the STARTUP BACKLIGHT STATE: OFF.
5) Press twice to return to the MAIN MENU.
FROM SIMPLE METER
1) Press to activate the MAIN MENU.
2) Press to activate the METER CONFIG MENU.
3) Press to activate the USER PREFERENCES menu.
4) Press to set the STARTUP BACKLIGHT STATE: OFF.
5) Press twice to return to the MAIN MENU.
NOTE ON BACKLIGHT OPERATION
I-3
INTRODUCTION