5-5
The TC Setup mode allows you to set the following which are necessary for recording/play-
back of time code or synchronizing the unit to external time code.
1. Editing time code generated by the internal TC generator
2. Editing the chase offset to external time code
3. Trimming the chase offset
4. Chase mode selection
5. Capturing the LTC time for storing it as the chase offset (Catch offset)
6. Editing the LTC start time
7. Force jamming to external time code
8. Selecting output time code
9. Time code output on/off selection while paused
10. TC user bit output selection
TC Setup mode details
HMSFSF
CHASEOFFSET
Flashing
• To enter the TC Setup mode
1. Press the [SHIFT] key to turn on the indicator, then press the [CHASE/(TC SETUP)] key.
The unit enters the TC Setup mode and the display shows a menu. The first time the unit enters the
TC Setup mode after turning on the power, the "Chase Offset?" menu is shown. Otherwise, the display
shows the menu previously selected.
HMSFSF
CHASEOFFSET
HMSFSF
CHASEOFFSET
HMSFSF
OFFSET
HMSF
GEN
2. Use the jog dial (or [SKIP/CURSOR] [|<<] / [>>|] keys) to select the desired menu.
You can cycle through menus in the following order (or reverse order).
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
HMSF
GEN
Flashing
Flashing
HMSFSF
