Filter
Top Products
18
Figure 7-2
7-INSTALLATION
2011 October
700aks-NA
Figure 7-1
7.4 Machine Set-Up / Bed Height
Adjust machine bed height. The case sealer is equipped
with four (4) adjustable legs that are located at the
corners of the machine frame. The legs can be
adjusted to obtain different machine bed heights
from 520mm [20 1/2 inches] minimum to 785mm [31
inches] maximum (see specifi cations).
Refer to Figure 7-3 and set the machine bed height as
follows:
1. Raise and block up the machine frame to allow
adequate leg adjustment.
2. Loosen, but do not remove, two (2) M8 x 16
socket head screws in one leg (use M6 hex
wrench). Adjust the leg length for the desired
machine bed height. Retighten the two (2) screws
to secure the leg. Adjust all four (4) legs equally.
Figure 7-3
M6
Socket Head
Wrench
Adjustable
Leg
A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
7.3 Tool Kit Supplied with the Machine
7.1 Operating Conditions
The machine should operate in a dry and relatively
clean environment (See Specifi cations).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
• To reduce the risk associated with
mechanical and electrical hazards:
− Allow only properly trained and
qualifi ed personnel to operate and service
this equipment.
WARNING
• To reduce the risk associated with
muscle strain:
− Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment.
− Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift.
WARNING