Filter
Top Products
33
Refer to Figure 13-8 and 13-9 and adjust belt tension as follows:
1. Remove and retain center plate/front cover and four screws.
2. Loosen, but do not remove, M10 lock nut with a 17mm open end wrench.
3. Reset the tension on the drive belts as needed. Adjust the M8 tension screws in (clockwise) to increase
tension or out (counterclockwise) to decrease tension. Tighten lock nut to secure tension setting.
4. Replace center plate/front cover and secure with original screws.
13-MAINTENANCE AND REPAIRS (continued)
Figure 13-8
Figure 13-9
Box Drive
Belts
Infeed End
Front Cover
13mm Box Wrench
M10 Lock Nut
Infeed End
M6 Hex Wrench
M10 Lock Nut
Center
Plate
M5 X 16 Flat
Hd Screw (4)
M5 X 10 Pan
Hd Screw (4)
M8 Hex Hd
Tension Screw
M5 Plain
Washer
M8 Hex Hd
Tension Screw
M8 Socket Hd
Tension
Screw (4)
2011 October
700aks-NA