Filter
Top Products
Wireless Multi-Function Access Point
A02-AP-W54 Pag. 6
2.2 The Front LEDs
The table below shows the LED Indicator of the Wireless Multi-Function Access
Point.
LED Meaning
POWER This indicator lights green when the Access Point receives
power. Otherwise, it turns off.
LAN The indicator lights green when the LAN port is connected to a
100Mbps Ethernet station, the indicator blinks green while
transmitting or receiving data on the 100Mbps Ethernet
network.
WLAN The indicator always blinks green while the wireless AP is
always broadcasting packets.
2.3 The Rear Ports
The figure below shows the rear panel of the Wireless Multi-Function Access
Point.
Port Meaning
Reverse SMA
Connectors
There are two antennas in the rear panel, when you
need to connect extended Antenna, connect to Antenna
2 for the extended antenna. When you are using one
antenna model, connect the extended antenna directly to
the antenna screw in the rear panel.
LAN
Ethernet uplink port with 10/100Mbps Fast Ethernet
connections, connect this port to switch/hub.
Reset
The Reset function is to reset the setting back to factory
default setting, once you press the “RESET” button
within 10 seconds, the LED of the WLAN will turn off.
And when the Access Point is ready, the WLAN LED will
start blinking.
And the other function is when the AP is locked, press
the reset button to unlock it.
POWER (DC-IN)
Connect the Power Ada
p
ter DC
p
lu
g
to the
A
P’s
p
ower