Filter
Top Products
Wireless Multi-Function Access Point
A02-AP-W54 Pag. 8
CHAPTER 3: Configuration
The Wireless Multi-Function Access Point can be configured with your Web
browser. The web browser is included as a standard application in the following
operation systems, UNIX, Linux, Mac OS, Windows 95/98/NT/2000/Me, and etc.
The product provides a very easy and user-friendly interface for configuration.
3.1 Before Configuration
This section describes the configuration required by LAN-attached PCs that
communicate with the Wireless Multi-Function Access Point, either to configure
the device or for network access. These PCs must have an Ethernet interface (or
wireless adapter) installed properly, be connected to the Wireless Multi-Function
Access Point either directly or through an external repeater hub or by wireless,
and have TCP/IP installed and configured to obtain an IP address through a
DHCP server or a fixed IP address that must be in the same subnet of the
Wireless Multi-Function Access Point. The default IP address of the Wireless
Multi-Function Access Point is 192.168.1.100 and subnet mask is 255.255.255.0.
Please follow the steps below for PC’s network environment installation. First of
all, please check your PC’s network components. The TCP/IP protocol stack and
Ethernet network adapter must be installed. If not, please refer to MS Windows
related manuals.
Any TCP/IP capable workstation can be used to communicate
with or through the Wireless Multi-Function Access Point to
configure other types of workstations, please consult the
manufacturer’s documentation.