Filter
Top Products
3. Setup of the B-10 Mobile LED
Image 3-3
Pump system
2. Push on the black button.
3. Lift the first halve of the LED-wall by using the lever
Lift this part of the display up till its 10 cm above the de
ckoftheB-10MobileLED.
Fastening both display halves together
1. Release the 4 fasteners of the bottom display and pull it below the top display.
Image 3-4
2. Bring down the upper display and position the bolts in the holes.
Note: Do not bring down the display much tha n needed!
3. Fasten the 2 halve displays tog
ether by fastening the bolts.
4. Plug in the 4 power cables and data cable.
Extending the full display
1. Extend the display to its top position.
2. Place the safety pieces in the mast.
R5976956 B-10 MOBILE LED 19/06/2007
23