Barco R9855510 Work Light User Manual


 
1. Safety instructions
1.5 Important Warnings
Important warnings
High leakage current:
The combination of multiple tiles in an installation results in increased levels of leakage current. In order to avoid risk of electric
shock due to high leakage current, proper grounding of the installation is required.
Flammable materials:
Keep flammable materials away from theB-10 Mobile LED generator. A lot of energy is transferred into heat. The installation
should be such that the amount of air flow required for safe operation of the equipment is not compromised. Proper ventilation
must be provided.
Mains cords:
The power cords delivered with this system have special properties for safety. They are not user serviceable. If the power cords
are damaged, replace only with new ones. Never try to repair a power cord.
1.6 Specific warnings for diesel-fueled generator
Check before operating the engine
If the engine is malfunctioning DO NOT operates until repairs are made.
Be sure all guards and shields are in place before operating the engine. Replace any that are damaged or missing.
DO NOT start the engine by shorting across starter terminals.
Handling of fuel and lubricants
Always stop the engine before refueling or lubricating.
DO NOT smoke or allow flames or sparks in your working area. Fuel is extremely flammable and explosive.
Never store flammable liquids in the engine compartment.
Refuel at a well-ventilated and open place. If fuel or lubricants spill, clean up immediately and properly dispose of.
DO NOT mix gasoline or alcohol with diesel fuel. The mixture can cause a fire.
Fire prevention
To avoid a fire, be alert for leaks of flammables from hoses and lines. Be sure to check for leaks from hoses and pipes, such
as fuel and hydraulic by following the maintenance check list.
To avoid a fire, do not short across power cables and wires. Check to see that all power cables and wires are in good condition.
Keep all power connections clean. Bare wire or frayed insulation can cause a dangerous electrical shock and personal injury.
Cautions against burns and battery explosion
To avoid burns, be alert for hot components during operation and just after the engine has been shut off. Such as the muffler,
muffler cover, radiator, piping, engine body, coolants, engine oil, etc.
Conducting safety checks and maintenance
Maintenance of the generator is only to be performed by a specialized service technician.
When performing safety checks or engine service, be sure the engine is level and well supported. Use approved stands de-
signed for this type of service.
Check or conduct maintenance after the engine, radiator, muffler, or muffler cover has cooled off completely.
When service is performed with two or more people present, take care to perform all work safely. Be aware of their location
especially when starting the engine.
1.7 Specific warning for the jockey wheel
About the load
A jockey wheel has a maximum allowed load of 250 Kg. When the load is exceeded, the jockey wheel and the folding system get
damaged.
R5976956 B-10 MOBILE LED 19/06/2007
5