Filter
Top Products
19
G-Converter Chassis
TECHNICAL: 0118 931 2233
General Keyboard Conventions
Only a few keys are required to configure the chassis and are summarised as follows:
→ (Right arrow) Moves the cursor to the next field to the right.
← (Left arrow) Moves the cursor to the next field to the left.
↑ (Up arrow) Moves the cursor to the next field upwards.
↓ (Down arrow) Moves the cursor to the next field downwards.
+ (Plus) or <SPACEBAR> Toggles the parameter value up to the next available setting.
− (Minus) Toggles the parameter value down to the next available setting.
<ENTER> or <RETURN> Accepts the current display page (otherwise the same as ↓).
<CTRL> and U Updates all changes.
<ESC> Abandons all changes since the last <CTRL> U.
<CTRL> and P Refresh screen.
Cursor Movement
The cursor symbol “>” is moved around the screen to the required field using the arrow
keys.
Parameter Changing
If it is possible to modify the field over which the cursor is placed, an appropriate message is
shown at the bottom of the screen. No message will appear if the field is non-configurable.
Pressing the Space bar, the “+” key or the “-“ key will cycle through the choices available for a
parameter.
Accepting all changes and Updating the Configuration
If “Control” and “U” are pressed at the same time after the configuration has been altered,
the configuration is updated at the local and remote end as necessary and held in non-volatile
Memory.