Filter
Top Products
29
G-Converter Chassis
TECHNICAL: 0118 931 2233
Abandoning Changes
Pressing ESC at any point before a configuration is updated will cause the message
“Abandon Changes? (y/n)” to appear at the bottom of the screen. If “n” is selected the
message will disappear and editing may continue. If “y” is pressed, all modifications will be
abandoned and the last updated configuration will be re-printed on the screen.
Changing the Configuration Page
The Configuration Page required, e.g. “Alarms”, is selected by moving the cursor to the
upper right area and pressing Enter when alongside the required page. The currently
selected page is indicated by a ‘*’.
Restoring the Factory Default Configuration
The system may be reset back to the factory default configuration by pressing CTRL-R four
times when the cursor is on the Terminal emulation page (see page 12). A ‘Confirm’ message
will be displayed before the configuration is reset. The previous configuration will be lost.
This method uses the 10Base–T RJ45 port (Ethernet) port. An SNMP management package
i.e. (Open View, SNMP) can be used along with the supplied MIB to manage the Card Cage
System.
If additional Channel Cards are installed after the initial installation, a new MIB may be
required, please contact Black Box for information
The MIB must be compiled and installed in accordance with the instructions for the specific
SNMP management application being used. You should refer to the user guide for your
SNMP management software for more details.