Black & Decker JS680V Saw User Manual


  Open as PDF
of 36
 
10
RIP & CIRCLE CUTTING (FIGURE J & K)
Ripping and circle cutting without a pencil line
are easily done with the rip fence and circle
guide(availableatextracost).
Using the screw supplied with the accessory
guide, position as shown in figure I and
thread the screw into the shoe to clamp the
fence securely.
When circle cutting, adjust rip fence so that
distance from blade to hole in cross bar is at
the desired radius and tighten screw. Place
saw so that hole in cross bar is over center
of circle to be cut (drill hole for blade or cut
inward from edge of material to get blade into
position).Whensawisproperlypositioned,
drive a small nail through hole in cross bar.
Using rip fence as a pivot arm, begin cutting
circle. For circle cutting, the cross bar should
be up, as shown in gure J.
When ripping, slide the rip fence under the
screw from either side of the saw. Set the
cross bar at desired distance from blade
and tighten screw. For ripping, the cross bar
should be down and against the straight edge
of the workpiece as shown in gure K.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unitwillnotstart. •Cordnotpluggedin. •Plugtoolintoaworking
outlet.
•Circuitfuseisblown. •Replacecircuitfuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
servicedataBlack&
Decker service center or
authorizedservicer.)
•Circuitbreakeristripped.  •Resetcircuitbreaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
servicedataBlack&
Decker service center or
authorizedservicer.)
•Cordorswitchisdamaged.•Havecordorswitch
replacedatBlack&
Decker Service Center or
Authorized Servicer.
• Shoeplateisloose. •Retainingscrewloose. •Loosenthescrewclosest
to the blade on the
underside of the shoe
plate.
K
J
 previous next