Filter
Top Products
Set-Up
TOOLS REQUIRED
◆ Screwdriver
◆ Two adjustable wrenches – or
two 3/4” open-end wrenches –
or any combination of the two
types
◆ Extension cord – see Table 1 on
Page 2.
Remove all components from the
box. Remove the cap from the hose
adapter and attach one end of the
high pressure hose to the sprayer
(see Figure 7). Attach the other end
of the hose to the gun.
PREPARATION
Each sprayer is tested at the factory.
Residual amounts of test fluid will
remain in the pump. If you are using
an oil-based coating (one that
5
EZ5000 Series
www.chpower.com
General Safety (Cont.)
◗ turn the unit to the Prime
position (see Figure 5) ...OR ...
◗ turn the unit to the Off posi-
tion (see Figure 6).
Be thoroughly familiar with the
controls.
To reduce the risk
of injury:
• Always wear appropriate gloves,
eye protection, and a respirator or
mask when painting.
• Do not operate or spray near
children. Keep children away from
equipment at all times.
• Do not overreach or stand on an
unstable support. Keep effective
footing and balance at all times.
• Stay alert and watch what you
are doing.
• Do not operate the unit when
fatigued or under the influence of
drugs or alcohol.
• Do not kink or over-bend the
hose.
• Do not expose the hose to tem-
peratures or to pressures in excess
of those specified by the manu-
facturer.
• Do not use the hose to pull or
lift the equipment.
!
WARNING
Figure 7 – Attach hose to sprayer
Figure 5 - Icon
showing Prime
position
Figure 6 - Icon
showing Off
position