Filter
Top Products
Page 13SKU 41213 For technical questions, please call 1-800-444-3353.
Controls
Polishing
Place a clean Polishing Bonnet (48) securely onto the Backing Pad (46).
Tie it
securely using the drawstring. Make sure to tuck any excess string inside the
Bonnet
Note: Prior to waxing or polishing a vehicle, make sure it’s surface has been
thoroughly washed, and is free of dust, dirt, oil, grease, etc.
Apply about two tablespoons of wax (not included) evenly on the Polishing Bon-
net (48). Do not apply the wax directly to the surface of the vehicle. The amount
of wax needed will vary according to the size of the vehicle being waxed.
IMPORTANT
Carefully inspect the condition of the accessory before use and check the accessory
continually during use. If any damage is noted, stop immediately and replace the accessory
with an undamaged one. Harbor Freight Tools cannot be held responsible for damage
caused by using a damaged accessory on this tool.
Note: Avoid using too much wax. For additional applications of wax to the Polish-
ing Bonnet (48), reduce the amount of wax. The Polishing Bonnet (48) will not
absorb as much wax in subsequent applications.
Plug the Power Cord (33) into an electrical extension cord (not included). Then,
plug the extension cord into a grounded, GFCI, 120 volt, electrical outlet.
Note: Always start and stop the Polisher while it is held rmly against the surface
of the vehicle. Failure to do so may result in the Bonnet being thrown from the
Backing Pad (46).
1.
2.
3.
Carefully inspect the condition of the accessory before use and check the
accessory continually during use. If any damage is noted, stop immediately
and replace the accessory with an undamaged one. Harbor Freight Tools
cannot be held responsible for damage caused by using a damaged
accessory on this tool.
WARNING
ON/OFF Switch (24)
OPERATING INSTRUCTIONS