Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 92880
Insert the battery pack into the Charger 4.
Base (25) by aligning the ribs on the
Charger Base with the grooves in the
battery pack. Press the battery pack into
place.
Press down on the battery pack to make 6.
sure that the contacts on the battery pack
are fully engaged with the contacts in the
charger unit.
7.
be lit, indicating that the charger is in
operation. During recharging, the battery
pack will become slightly warm to the
touch. This is normal and not a cause for
concern.
Do not place the battery and charger in 8.
an environment of extreme heat or cold.
They will work best at room temperature.
9. Note: The Charger Base (25) will
not shut off automatically. When the
hours), unplug the battery charger and
remove the battery pack. Do not leave
the battery in the Charger Base (25)
Installing the Battery Pack
Place the battery pack in the tool, aligning 1.
the arrows on the battery pack with the
arrows on the tool.
Press the battery pack into the tool. Make 2.
sure that the battery pack snaps into
place, and that the battery pack is secure
in the tool before beginning use.
Removing the Battery Pack
Press the Release Tabs (19) on both 1.
sides of the battery pack to release the
battery from the tool.
Remove the battery pack from the tool by 2.
pulling straight out.
INSTRUCTIONS FOR PUTTING
INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the tool
off and remove the Battery Pack
before assembling or making any
adjustments to the tool.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Work Piece and Work Area Set Up
Designate a work area that is clean and 1.
access by children or pets to prevent
Route the power cord along a safe 2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
Secure loose work pieces using a vise 3.
or clamps (not included) to prevent
movement while working.
4.
nearby that will present a hazard while
working.
REV 10e