Filter
Top Products
Page 13For technical questions, please call 1-800-444-3353.SKU 93632
Troubleshooting
Drill operates but hole is not 1.
effectively drilled.
Possible Cause:a. Inappropriate or dull
drill bit.
Solution: Try a different drill bit.
Drill will not turn ON.2.
Possible Cause:a. No power source.
Solution: Check that the power cord
is plugged into an appropriate live
outlet. Check that power cord is in good
condition.
Possible Cause:b. Damaged Carbon
Brushes.
Solution: Unplug tool. Remove and
inspect Carbon Brushes. If glazed, they
can be cleaned with a pencil eraser. If
chipped, cracked or worn out, they must
be replaced. Reinstall good Carbon
Brushes. Plug in tool and try again.
Possible Cause:c. Damaged or burned
out Rotor or Stator.
Solution:
technician for replacement or repair.
Drill bit “wobbles” in Chuck.3.
Possible Cause:a.
drill bit.
Solution: Unplug tool from power supply.
carefully. Tighten securely.
Possible cause:b. Chuck is loose on
Spindle (12).
Solution: Tighten the Chuck onto the
Spindle by turning clockwise.