Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 68885
Wire Spool Installation
1. Turn the welder OFF and unplug
it before proceeding.
2. Pull up on the door latch,
then open the Door.
3. Remove the Spool Knob, Spool Spring, and upper
Spool Plate. If replacing a Spool, remove the old
Spool and all remaining wire from the liners.
4. Place the new Wire Spool over the Spool Spindle
and on top of the lower Spool Plate as illustrated.
To prevent wire feed problems, set the
Spool so that it will unwind clockwise.
5. Secure Spool in place with the upper Spool Plate
(narrower end against the Spool),
then the Spool Spring and Spool Knob.
MIG 170
WIRE FEED WELDER
ITEM 68885
WIRE FEED SPEED
20A
240V~
Wire
.023″-.035″
(Tip and roller change required)
Capacity 22 Ga. – 1/4″ Steel Plate
Material
Types
Mild Steel and Stainless Steel
(Not for welding Aluminum.)
I
O
door
latch
Door
Spool Knob
Wire Spool
Lower
Spool Plate
Upper
Spool Plate
Spool Spring
Spool Spindle
wire must
unwind this
direction
SAFETYMAINTENANCE BASIC WELDINGWELDING TIPS SETUP