Filter
Top Products
Page 12SKU 90891 For technical questions, please call 1-800-444-3353.
1/4” MOUNTING HOLE
1/4” MOUNTING HOLE
FIGURE F
FRONT COVER
WITH SUPPORT
LEG (117)
Use two C-clamps (not included) to secure the back side of the Miter Saw to the
table/workbench.
To Remove/Install A Saw Blade:
WARNING! Prior to performing this procedure, make sure the Miter Saw is un-
plugged from its electrical outlet.
When replacing a Saw Blade (51), make sure the new Saw Blade has a 10”
diameter, rated to at least 4600 RPM, made to t a 5/8” (0.625”) Spindle, and
suited for the type of material being cut.
SAFETY COVER (58)
FIGURE G
SAW BLADE (51)
Lift up and hold the transparent Safety Cover (58) in place. (See Figure G.)
3.
1.