Filter
Top Products
Page 19SKU 90891 For technical questions, please call 1-800-444-3353.
To Adjust The Support Screw:
The Support Screw (138) can be
adjusted by turning it clockwise to
lengthen it or by turning it counter-
clockwise to shorten it.
It should be adjusted so that it rests
just above the surface of the table or
bench the saw is mounted on.
1.
2.
To Adjust The Bevel Angle:
WARNING! Prior to performing this procedure, make sure the
Power Cord of the Miter Saw is unplugged from its elec-
trical outlet.
SCALE PLATE
(89)
LOCK HANDLE
(59)
ARM HOLDER
(82)
FIGURE O
SUPPORT SCREW
(138)
The bevel angle (or Saw Blade tilt capacity) may be adjusted
from 0 - 45 degrees to the left. To do so, loosen the Lock Handle (59) located at
the rear of the Miter Saw. (See Figure O.)
Tilt the Arm Holder (82) until the desired compound angle of cut is achieved as
indicated on the Scale Plate (89). Then, retighten the Lock Handle (59) to lock
the Arm Holder in place. (See Figure O.)
To Adjust The Support Screw:
The Support Screw (138) can be adjusted by turning it clockwise to lengthen it or
by turning it counterclockwise to shorten it.
It should be adjusted so that it rests just above the surface of the table or bench
the saw is mounted on.
1.
2.
1.
2.