Filter
Top Products
A-16
Cisco ASA 5500 Series Hardware Installation Guide
78-16409-03
Appendix A Maintenance and Upgrade Procedures
Removing and Replacing the Power Supply
Replacing the AC Power Supply
To replace the AC power supply, perform the following steps:
Step 1 Insert the new power supply into place and slide it towards the back of the adaptive security appliance.
Step 2 Lift the rear of the adaptive security appliance from the surface and reinstall both screws.
Step 3 Insert the power supply brace and press down until it fits into place, as shown in Figure A-16.
Figure A-16 Replacing the Power Supply Brace and the AC Power Supply
Step 4
Connect the power connector to the system board.
Step 5 Replace the adaptive security appliance cover. See the “Replacing the Chassis Cover” for more
information.
Step 6 Reinstall the network interface cables.
1 Back panel 3 Power supply brace
2 Power supply 4 Front panel
119579
3
1
2
4