Filter
Top Products
A-6
Cisco ASA 5500 Series Hardware Installation Guide
78-16409-03
Appendix A Maintenance and Upgrade Procedures
Installing and Replacing the 4GE SSM
Installing the SFP Module
To install the SFP module in the 4GE SSM, perform the following steps:
Step 1 Line up the SFP module with the port and slide the SFP module into the port slot until it locks into
position as shown in Figure A-4.
Figure A-4 Installing an SFP Module
Caution Do not remove the optical port plugs from the SFP until you are ready to connect cabling.
Step 2 Remove the Optical port plug; then connect the network cable to the SFP module.
Step 3 Connect the other end of the cable to your network. For more information on connecting the cables, see
“Connecting the Interface Cables” section on page 2-7.
Caution The latching mechanism used on many SFPs locks them into place when cables are connected. Do not
pull on the cabling in an attempt to remove the SFP.
1 Optical port plug 2 SFP port slot
3 SFP module
132985
1
3
2