Filter
Top Products
3-15
Cisco 880 Series Integrated Services Router Software Configuration Guide
OL-22206-01
Chapter 3 Basic Router Configuration
Configuring WAN Interfaces
login
transport input all
!
exception data-corruption buffer truncate
end
Verifying ADSL Configuration
Verify that the configuration is set properly by using the show controller vdsl 0 command from the
privileged EXEC mode. Outputs in bold are critical.
Router# show controller vdsl 0
Controller VDSL 0 is UP
Daemon Status: Up
XTU-R (DS) XTU-C (US)
chip Vendor ID: ‘BDM’ ‘BDCM’
Chip Vendor Specific: 0x0000 0x6110
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: ‘csco’ ‘BDCM’
Modem Vendor Specific: 0x4602 0x6110
Modem Vendor Country: 0xB500 0xB500
Serial Number Near: FHK1313227E 887-V2-K 15.1(20100
Serial Number Far:
Modem Version Nead: 15.1(20100426:193435) [changahn
Modem Version Far: 0x6110
Modem Status: TC Sync (Showtime!)
DSL Config Mode: AUTO
Trained Mode: G.992.5 (ADSL2+) Annex A
TC Mode: ATM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Trellis: ON ON
Line Attenuation: 1.0 dB 1.4 dB
Signal Attenuation: 1.0 dB 0.0 dB
Noise Margin: 6.8 dB 13.6 dB
Atteinable Rate: 25036 kbits/s 1253 kbits/s
Actual Power: 13.7 dBm 12.3 dBM
Total FECS: 0 0
Total ES: 0 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 0 0
Total LPRS: 0 0
Total LOFS: 0 0
Total LOLS: 0 0
Bit swap: 163 7
Full inits: 32
Failed Full inits: 0
Short inits: 0
Failed short inits: 0