Filter
Top Products
4-2
Cisco 880 Series Integrated Services Router Software Configuration Guide
OL-22206-01
Chapter 4 Basic Wireless Device Configuration
Starting a Wireless Configuration Session
Starting a Wireless Configuration Session
Note Before you configure the wireless settings in the router’s setup, you must follow these steps to
open a session between the router and the access point.
Enter the following commands in global configuration mode on the router’s Cisco IOS CLI.
SUMMARY STEPS
1. interface wlan-ap0
2. ip address subnet mask
3. no shutdown
4. interface vlan1
5. ip address subnet mask
6. exit
7. exit
8. service-module wlan-ap 0 session
DETAILED STEPSf
Command Purpose
Step 1
interface wlan-ap0
Example:
router(config)# interface wlan-ap0
router(config-if)#
Defines the router’s console interface to the wireless
device. The interface is used for communication
between the router’s console and the wireless device.
Always use port 0.
The following message appears:
The wlan-ap 0 interface is used for managing
the embedded AP. Please use the service-module
wlan-ap 0 session command to console into the
embedded AP.
Step 2
ip address subnet mask
Example:
router(config-if)# ip address
10.21.0.20 255.255.255.0
or
router(config-if)# ip unnumbered vlan1
Specifies the interface IP address and subnet mask.
Note The IP address can be shared with the IP
address assigned to the Cisco Integrated
Services Router by using the ip unnumbered
vlan1 command.
Step 3
no shutdown
Example:
router(config-if)# no shutdown
Specifies that the internal interface connection will
remain open.