Filter
Top Products
G ETTING TO RN OW YOUR
6 11
8 BLADE GUARD 7 MITER GAUGE
SAW
0 SAWBLADE
ON-OFF SWITCH
TABLE INSERT
i TILT LOCK KNOB
ELEVATION LOCK HANDLE
ELEVATION CRANK
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the blade
guard iscorrectly installed and operating properly.
The On-Off Switch hasa locking feature. THIS FEATURE
IS INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE BY CHILDREN AND
OTHERS.
B. TO turn saw ON . .. stand to either side of the
blade never in line with it ... insert finger under
switch leverand pull END of lever out.
After turning switch ON, always allow the blade to
come up to full speed before cutting.
Do not cycle the motor switch on and off rapidly,
as this may cause the sawblade to loosen. In the
event this should ever occur, allow the sawblade to
come to a complete stop and retighten the arbor
nut normally, not excessively. Never leave the saw
while the power is "ON".
C. TO turn saw OFF ... PUSH lever in. Never leave
the saw until the cutting tool has come to a
complete stop.
D. TO lock switch in OFF position ... hold switch IN
with one hand ... REMOVE key with other hand.
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW
TABLE SURFACE. {IF BLADE IS TILTED,
RETURN IT TO VERTICAL (90°) POSITION).
ALWAYS LOCK THE SWITCH "OFF". WHEN
SAW IS NOT IN USE ... REMOVE KEY AND
KEEP IT IN A SAFE PLACE ... ALSO ... tN
THE EVENT OF A POWER FAILURE (ALL OF
YOUR LIGHTS GO OUT) TURN SWITCH OFF
... LOCK IT AND REMOVE THE KEY. THIS
WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK DIM.
TILT CRANK
KEY
(YELLOW PLASTIC)
\
KEY
@
14