Filter
Top Products
Insert forefinger into table-insert slot and pull upward to
remove insert.
Replace insert. If clips do not hold insert securely, remove
insert and bend clips.
SPRING CLIP
BEND CLIPS
AS NEEDED
SPRING CLIP
CHECKING BLADE SQUARENESS TO TABLE
1. Loosen ELEVATION LOCK by pulling KNOB forward.
2. Turn ELEVATION crank clockwise until blade is as
high up as it will go.
IMPORTANT: BLADE must be SQUARE (90° ) to
TABLE, in order to ALIGN rip fence.
3. Check for BLADE SQUARENESS ... if blade is not
square to table, adjust it at this time.
4. Refer to "BLADE TILT, OR SQUARENESS OF
BLADE TO TABLE" adjustmenst on page24.
MAKE SURE SQUARE
IS NOT TOUCHING
TIP OF TOOTH
TILT CLAMP KNOB-
ELEVATION CRANK
TILT CRANK
ELEVATION LOCK KNOB
ATTACHING TABLE EXTENSIONS
1. From among the loose parts find the following
hardware:
8 Hex Head Screws 5/16 in. - 18x 1-1/4 in. long
8 Lockwashers, 5/16 in. External Type (approx. dia. of
hole 5/16 in.)
8 Hex Nuts, 5/16in.- 18 (approx. dia. of hole 5/16 in.)
Insert screws through holes in EXTENSION then through
table. Install Iockwashers and screw on the nuts . .. DO
NOT TIGHTEN.
Align front edge of extension with front edge of saw table.
Pull Extension UPWARDS above table surface ...
SLIGHTLY TIGHTEN SCREWS using 1/2 in. wrench.
Using small block of hardwood andhammer, tap extension
DOWNWARDS at front, center & rear, until it is EVEN
with table surface ... TIGHTEN SCREWS.
BLOCK OF WOOE
\