Filter
Top Products
24 25
24 25
bevel angle adjustment bolt (10)
and use a 10 mm wrench to adjust
the stop bolt (10) depth in or out
to increase or decrease the bevel
angle.
4. Tilt the cutting arm to the left to 45°
bevel and recheck for alignment.
5. Repeat steps 1 through 4 until the
blade is at 45° to the miter table.
6. Tighten bevel lock handle (8) and
locknut (9) when alignment is
achieved.
Fig. Q
MITER ANGLE ADJUSTMENT (FIG.
R)
The sliding compound miter saw scale
can be easily read, showing miter
angles from 0° to 45° to the left, and 0°
to 45° to the right. The miter saw table
has nine of the most common angle
setttings with positive stops at 0°, 15°,
22.5°, 31.6°, and 45°. These positive
stops position the blade at the desired
angle quickly and accurately. Follow
the process below for quickest and
most accurate adjustments.
1. Unlock the miter table by turning the
miter handle (1) counterclockwise.
2. Move the turntable while lifting up
on the positive stop locking lever
(2) to align the indicator (3) to the
desired degree measurement.
3. If the desired angle is one of the
nine positive stops, release the
positive stop locking lever, making
sure the lever snaps into position,
and then secure by tightening the
miter handle.
4. If the miter angle desired is not one
of the nine positive stops, simply
lock the miter table into desired
angle position by turning the miter
handle in the clockwise direction.
Fig. R
MITER SCALE INDICATOR
ADJUSTMENT (FIG. R)
1. Move the table to the 0° positive
stop.
2. Loosen the screw (4) that holds the
indicator with a Phillips screwdriver.
3. Adjust the indicator (3) to the 0°
mark and retighten screw.
ADJUSTING FENCE SQUARENESS
(FIG. S)
1. Lower the cutting arm and lock in
position.
2. Using a square (3), lay the heel of
the square against the blade and
3
2
4
1
8
10
9