Filter
Top Products
40 41
40 41
PROBLEM PROBLEM CAUSE
SUGGESTED CORRECTIVE
ACTION
Blade hits table. 1. Misalignment. 1.
See ADJUSTMENT -Setting
Cutting Depth section.
Angle of cut not
accurate. Can
not adjust miter.
1. Miter table unlocked.
2. Sawdust under table.
1.
See OPERATION - Miter Angle
Adjustment section.
2.
Vacuum or blow out dust. WEAR
EYE PROTECTION.
Cutting arm
wobbles.
1. Loose pivot points. 1.
Contact Sears Service Center.
Cutting arm will
not fully raise, or
blade guard
won’t fully close.
1. Pivot spring not replaced
properly after service.
2. Sawdust build-up.
1. Contact Sears Service Center.
2. Clean and lubricate moving
parts.
Blade binds,
jams, burns
wood.
1. Improper operation.
2. Dull or warped blade.
3. Improper blade size.
4 Wood is moving during
cut.
1. See BASIC SAW OPERATION
section.
2. Replace or sharpen blade.
3. Replace with 7-1/4 in. diameter
blade.
4. Use hold down clamp to secure
workpiece to table.
Saw vibrates or
shakes.
1. Saw blade not round /
damaged / loose.
2. Arbor bolt loose.
1. Replace blade.
2. Tighten arbor bolt.
TROUBLESHOOTING GUIDE - SAW OPERATION