Filter
Top Products
2 3
2 3
ROTATING TABLE:
Diameter............................................................................ 9-1/32 in.
Miter Detent Stops ............................................................ 0, 15, 22.5, 31.6, 45º R & L
Bevel Positive Stops ......................................................... 0, 45º L
CUTTING CAPACITY:
Crosscut ............................................................................
2 in. x 8 in.
Miter 45
° R & L................................................................... 2 in. x 6 in.
Bevel 45º L......................................................................... 1-1/2 in. x 8 in.
45° Miter and 45° Bevel..................................................... 1-1/2 in. x 6 in.
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be
connected to a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these
safety rules. Failure to follow these rules could result in serious injury to
you or damage to the tool.
MOTOR
Power Source ..................................................................... 9Amp, 120V AC, 60Hz
Speed ................................................................................. 5000 RPM (No load)
Brake .................................................................................. Electric
Double Insulated .................................................................
Yes
BLADE SIZE
Diameter.............................................................................. 7-1/4 in.
Arbor size............................................................................ 5/8 in.
PRODUCT SPECIFICATIONS