Filter
Top Products
A'I-I'ACHtNGREPLACEMENT BLADES TO THE SAW cont. (See Figs. 17 -20)
8, Place the pin (includedwiththe
wrench) into the lined up holes, Fig, 20
9, Tighten the lock nut clockwisewith
the wrench and then remove the pin
from the blades(see Fig.20), This will
allow the blades to turn freely.
10. Carefully turn blades withyour hand
to be sure they easily turn in
opposite directions.
Lock Nut
GENERAL
/_ WARNING: To avoidaccidents,ALWAYS disconnectthetoolfrom the Ipower source BEFORE cleaningor performingany maintenance.
All parts representan importantpart of the doubleinsulationsystemand shouldbe
serviced only at a Sears Service Center.
Avoidusingsolventswhen cleaningplasticpads. Most plasticsare susceptibleto
damage from varioustypesof commercialsolventsand may be damaged by their use.
Use clean clothsto remove dirt,carbondust, etc.
/_ WARNING: DO NOT at anytimeletbrakefluids,gasoline,petroleum-based I
products,penetratingoils,etc.to comeincontactwith plasticparts.They contain
I
chemicalsthat can damage, weaken or destroyplastic.
It is a knownfact thatelectrictoolsare subjectto acceleratedwear and possible
prematurefailure whentheyare usedto workon fiber glassboatsandsportscars,
wallboard,specklingcompoundsor plaster.The chips and grindingsfrom these
materials are highlyabrasiveto electricaltoolparts,such as bearings,brushes,
commutators,etc.Consequently,it is not recommendedthat thistoolbe usedfor
extendedworkon any fiber glassmaterial,wallboard,spacklingcompound,or piaster.
Duringany use onthese materials,it is extremelyimportantthatthetoolis cleaned
frequentlyby blowingwithan air jet.
•/1\ WAR NING: ALWAYSwearsafetygogglesor safetyglasseswithsideshields I
orface shieldwhenblowingdustfrom toolwhencleaningit.Ifoperationis dusty,also
wear s dustmask.
19