Filter
Top Products
assembly
Before mountingthe saw on legs, a stand ora bench, the
Table Insert and Blade Squareness must be checked at
this time.
INSTALLING HANDWHEELS
1. Line up FLAT SPOTS onshaft and Handwheel, push
Handwheel onto shaft. Installscrew and Iockwasher
to lock Handwheel on shaft.
ELEVATION
HANDWHEEL
LOCKWASHER
10-32 X 314 IN.
PHILLIPS
HEAD SCREW
TILT HANDWHEEL
CHECKING TABLE INSERT
1. Insert should be flush with table top, Check as
shown. Loosen flat head screw that holds Insert and
adjust the four set screws as necessary. -tighten flat
head screw. Do nottighten screw to the pointwhere
it deflects the Insert.
3/32 IN
SETSCREW WRENCH
2. To remove Insert.
A. Loosen Screw
B Lift Insert from front end, and pulltoward front of
saw,
3, To replaceinsert.
A. Place Insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten
screw.
B. Do not tighten screw to the point where it will
deflect the Insert.
CHECKING BLADE SQUARENESS TO
TABLE
IMPORTANT: BLADE must be SQUARE (90°) to
TABLE, in order to proceed with assembly.
1. "rum Elevation Handwheelclockwise untilblade isup
2. Check for BLADE SQUARENESS. If blade is not
square to table, adjust it at this time,
Contents" section
Refer to "Blade Tilt, or Squareness of Blade to Table"
adjustment on page 39.
MAKESURESQUARE
ISNOTTOUCHING
TIPOFTOOTH
/
/
10