Craftsman 298721 Saw User Manual


 
assembly
5. From among the loose parts, find the following
hardware:
*4 Carriage Bolts, 5/16-18 x 3/4
*4 Hex Nuts 5t16-18
*4 Lockwashers, 5/16 External Type
1 Motor Pulley
1 Belt Guard "L" Bracket
1 Belt Guard Support Bracket
Items marked with an asterisk (*) are shown actual size.
= == i ,=,,,,,H i , i= ,1=
POSITIONING MOTOR ON MOTOR MOUNTING
_ BELT GUARdeD
BELTGUARD MOTOR SUPPORT BRACKET
"L_BRACKET PULLEY
5/16-18 x 3/4 IN
CARRIAGE BOLT
LOOSEN BOTH CRADLE CLAMP SCREWS
5/16-18 5/16 IN EXTERNAL
HEX NUT LOCKWASHER
BASE
Model 113.298761
1. Put the motormounting base against the flat surface
of a workbench.
2. Positionthe motor so the end with terminal cover is
facing you.
3. Loosen both cradle clamp screws.
4. Put a square against the LEFT side of the motor and
against the top of the workbench.
r.---
5. Turn the motor inside the cradle clamps untilthe top
of both capacitors touch the square
6. Tighten bothcradle clamp screwsIo holdthe motor in
this position.
WARNING: Failure to properly Install motor may let
workplece strike capacitor cover during bevel or
compound miter cuts.
=l
CAPACITORS"
SQUARE
MOTOR
MOTOR MOUNTING
BASE
WORK BENCH
MOUNTING MOTOR ON MOTOR BASE
Model 113.298721 & 113.298761
1. Place Motoron MotorBase so that shaft is pointing
to the right. Insert bolts through holes in Base, then
throughthe MotorMountingBase. Installlockwashers
and nuts, DO NOT TIGHTEN AT THIS TIME.
2. Position Motor so that edge ofMotor Foot and Motor
Base are even. Slide Motor allthe way to the RIGHT.
Slip the long part of the "L" Bracket fully under the
Motor so the short part is just under shaft (Model
113.298721 only). Tighten the fournuts.
WELDED MOTOR
MOUNTING BASE
THESE TWO
EDGES EVEN
LOCKWASHER
5/16 IN.
5/16-18
CARRIAGE BOLT
5116-18 X 3/4 iN.
away from Motor. DO NOTTIGHTEN SETSCREW.
4. Install 3116 inchsquare key (furnished with Motor) in
groovesin PulleyandMotorshaft. DONOTTIGHTEN
SETSCREW.
, = =
INSTALUNG BELT
Model 113.298721 & 113.298761
1. Lift Motor and insert the TWO PINS on Motor Base
into HOLES in Cradle. Push Motor in as far as itwill
go.
BELT GUARD SUPPORT "" PULLEY
INSERTED EVEN WITH
MOTOR END HUB
2. Lowerthe blade, installBelt on Saw Pulley and Motor
Pulley.
3. Sight along edges of both pulleys and move Motor
Pulley so that belt is parallel to the edges of bol
Pulleys. Tighten the set screw in the Motor Pulley.
22