Filter
Top Products
assembly
6. Slide the Barssothat screwsare inthe MIDDLE ofthe
slotted holes.
7. PositionRipFenceoverMiterGaugeGroove, holding
up the rear end while engaging front end with Bar.
Lower Fence onto table.
8. Raise blade all the way up.
9. Carefully move Fence against blade.
10. Move Front Bar until "0" mark on Rip Scale is
approximately in line with tip of Pointer.
11. Move Front Bar upwards until Fence is approxi-
mately 1/32 inch above table. l-_Jhten screw at left
end of Bar.
NOTE: Fold a piece of newspaper making 8 thick-
nesses and place between Rip Fence and table to
act as a spacer. This will hold the Fence off of the
table approximately 1/32 inch.
12. Adjust Rear Bar so that the Fence is approximately
1/32 inch above table, make sure it is square with
Miter Gauge Groove. Tighten screw at end of Bar.
8THICKNESSES
OF PAPER
13. Move Fenceto RIGHTedge of table. Make sure it is
approximately 1/32 inch above table at front and
rear and tighten screws.
8 THICKNESSES
16