Filter
Top Products
assembly
iNSTALLiNG BELT GUARD
Model 113.298721 & 113.298761
1. install three Clips (furnished with Guard) 90° apart
starting with one Clip at the end of the Guard as
shown. LONG END of Clip facing AWAY from you.
BELT GUARD
OPENING
_ CLIPS
N
LONG END
2. Reinstall Motor Pulley the same way it waswhen you
aligned the Belt,
3. Place Belt on Saw Pulley. Insert end of Bell through
opening in END of Guard.
4. Slip Belt over Motor Pulley.
BELT
5. Press Guard onto Support sothat bottom of Guard is
approximately 3/4 inch away from Belt.
NOTE: To remove Guard, lift up on LONG TABS of
Clips, pull Guard outward. The Clips should remain
on the Belt guard Support.
3/4 iN.
PLUGGING iN MOTOR
1. From among the loose parts find:
2 Wire Ties
2. Route Motor Cord along dghtside ofcabinet and snap
ties in 1/4 inch bole in side ofcabinet. Secure cord in
wire ties,
3. Plug Motor cord into outlet on side of switch box.
WIRE TIES
24
EXTENSION REMOVED FOR
PICTURE CLARITY