Filter
Top Products
PRODUCT SPECIFICATIONS
Rating
No load Speed
Peak HP
Input
CoIlets/Nuts and Cutting Bit Shank Diameters
Fixed Base Diameter
Sub Base Opening (Diameter for cutting bit use)
Sub Base Thickness
Fixed Base Depth of Cut
12.,5 Amps
12000-25000RPM
2-1/4
120-volts, 60Hz AC
1/4 in, 1/2 inn
6 inches
14/4 inches
&23 inches (6mm)
1-3/4 inches (45mm)
NOTE: Before attempting to use your router, familiarize yourself with all of
the operating features and safety requirements.
Your fixed base router has a precision-built electric router motor and it should
only be connected to a 120wolt, 60-Hz AC ONLY power supply (normal house-
hold current). DO NOT operate on direct current (DC). This large voltage drop will
cause a loss of power and the router motor will overheat,, tf the router does not
operate when plugged into a correct 120-volt, 60-Hz AC ONLY outlet, check the
power supply. This router has al 0-ft, 2-wire power cord (no adapter needed).
This Fixed Base Router has the following features:
1. 12.5 Amp, 2-1/4 Peak HP, Variable Speed Router Motor runs at 12,000 to
25,000 RPM (no-load speed).
2_
3.
4_
.
Speed Dial allows matching proper speed to material and bit size°
Electronic Feedback Circuitry provides soft starts for longer motor life,
maintains constant speed under load for a quality finish in all materials.
Fixed Base features Coarse and Fine Depth Adjustments for accurate set-
ups° Ideal for use with router table, sotd separately.
Spindle Lock for easy 1 wrench bit changes. Includes 1/4 and 1/2 inch
Self-Releasing Collets/Nuts for use with a wide variety of 1/4 inn and 1/2 in,
router bits, sold separately.
6, Detachable power cord: a replaceable cord to prolong tool life and for easy
carrying and storage°
7. Ball bearings throughout the motor for smooth, efficient operation and bng life.
& Base features Ergonomically Designed Handles with soft grip for comfort,
maximum control with less vibration.
9. Base features Large Base Opening and Large Chip Shield, combined wit;'] 3
LED Work lights on Router Motor to provide high visibility of bit and work piece°
28190 ManuaLRevised O7-O409 Page 14