Filter
Top Products
,_ CAUTION: Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools or other obstructions
while you are working with a power tool.
WARNING: Check extension cords before each use. If damaged replace
immediately. Never use tool with a damaged cord since touching the dam-
aged area could cause electrical shock, resulting in serious injury.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols.
V ........................................................Volts
A ............................................................. Amps
Hz ......................................................Hertz
W ............................................................. Watts
min ................................................... Minutes
"_" .................................................. Alternating current
---= ................................................. Direct current
no ................................................... No-load speed
[] .......................................................... Class ii construction, Double Insulated
,../rain ................................................. Revolutions or Strokes per minute
_k .................................................... Indicates danger, warning or caution, it means
attention! Your safety is involved.
SERVICE SAFETY
if any part of this router is missing or should break, bend, or fail in any way;
or should any electrical component fail to perform properly: SHUT OFF the
power switch and remove the router plug from the power source and have the
missing, damaged or failed parts replaced BEFORE resuming operation,
Tool service must be performed only at a Sears Parts and Repair Center.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
When servicing a tool, use only identical replacement parts. Follow in-
structions in the maintenance section of this manual. Use of unauthorized
parts or failure to follow maintenance instructions may create a risk of electric
shock or injury.
28190 Manual_ReTised 07-0409 Page 7