Filter
Top Products
_k WARNING: To ensure safety and reliability, all r_pairs should be per-,
formed by a qualified service technician at a Seard Service Center=
GENERAL
Only the parts shown on the parts list are intended for repair or replacement by
the customer. All other parts represent an important part of the double insulation
system and should be serviced only by a qualified Sea_rs service technician.
_k WARNING: For your safety, ALWAYS turn off swiich and unplug muter mo-
tor from the power source before performing any maintenance or cleaning.
It has been found that electric tools are subject to acce_lerated wear and possible
premature failure when they are used to work on fiber _lass boats and sports
cars, wallboard, spackling compounds or plaster, The _hips and grindings from
these materials are highly abrasive to electrical tool pairs, such as bearings,
brushes, commutators, etc. Consequently, it is not recommended that this tool
be used for extended work on any fiberglass material, _allboard, spackling com-
pound or plaster° During any use on these materials, it is extremely important that
the tool is cleaned frequently by blowing with an air jetJ
A_k WARNING: Always wear safety goggles or safe_y glasses with side
shields during power tool operations, or when blov_ing dust. if operation is
dusty, also wear a dust mask.
ROUTINE MAINTENANCE
A_k WARNING: DO NOT at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic, which may result in seri-
ous personal injury.
o When work has been completed, clean the tool to _llow smooth functioning of
the tool over time. I
= Use clean damp cloths to wipe the tool
• Check the state of all electrical cables.
= Keep the router motor air openings free from oil, gr4ase and sawdust or
woodchips, and store tool in a dry place.
= Be certain that all moving parts are well lubricated, _aarticularly after lengthy
exposure to damp and/or dirty conditions.
WARNING: For your safety, ALWAYS turn off switch and unplug muter mo-
tor from the power source before performing any m_jntenance or cleaning.
!
Refer to ColletiNut Care and Cutting Bits on page t 7 f_r cleaning and care
!
28190 Manual Revised_0743409 I Page 33