Filter
Top Products
2. Make sure that the latch on the battery pack snaps into place and the battery
pack is secured to the tool before beginning operation.
TO DETACH BATTERY PACK (Fig. 3}
,_ CAUTION: Avoid the possibility of accidental starting: always take care
not to activate the trigger switch when attaching the battery pack or making any
adjustment to the tool.
1. Depress both battery-release buttons located on the sides of the battery
pack to release the battery pack.
2. Pull battery pack out and remove it from the tool.
,_ CAUTION: When placing the battery pack in the tool, be sure the raised rib
on the battery pack aligns with the groove inside the Auto-Hammer and that the
battery snaps into place properly. Improper assembly of the battery pack can
cause damage to internal components.
TRIGGER SWITCH (Fig. 4)
To turn the hammer ON,
depress the trigger switch. To
turn it OFF, release the trigger.
LED WORKLIGHT (Fig. 5)
The LED worklight, located on
the base of the Auto-Hammer,
will come on when the trigger
switch is depressed. The LED
worklight will turn off when the
trigger switch is released. This
provides additional lighting on
the surface of the workpiece for
operation in lower-light areas.
Fig. 4
Fig. 5
LED Worklight
61352 Manual_Revised_08 0924 Page 14