Filter
Top Products
Recommended Nails to Use
The Auto-Hammer is versatile for use with a variety of nails. Nails with diameters
less than 7/16-in and lengths equal to or less than 2-1/2 in. are recommended
for use with this Auto-Hammer.
Refer to below table for recommended nails to use with:
NO.
1
2
3
4
5
6
7
Nail Type Size Shank
Diameter
Bright Common 4d 0.1"
Bright Finish 6d 0.091"
Bright Finish 4d 0.072"
Coated Sinker 4d 0.08"
Electro Galvanized Roofing 4d 0.12"
Hot tipped Galvanized finish 10d 0.115"
Tempered Hard Trim 6d 0.07"
Head Length
Diameter
1/4" 1 1/2-in
9/64" 2-in
7/64" 1 1/2-in
13/64" 1 3/8-in
1/4" 1 1/2-in
3/8" 3-in
9/64" 2-in
Recommended Nailing Materials for the Auto-Hammer
The Auto-Hammer may be
used for nailing into all types
of woods, wood-like materials,
and plaster board.
,_ Note: The tool is not
suitable for nailing in hard metal
or concrete.
Use of Nail Remover (Fig. 7)
Your Auto-Hammer comes with
a 5-1/2" nail remover for use
with most finishing nails that
can be used with this tool.
1. Slip the front tip underneath
the nail head.
2. Pull out nails as shown
in Fig. 7.
61352 Manual_Revised_08 0924 Page 16