Filter
Top Products
13
WARNING
Plugging in saw during assembly
could result in electrical shock, or
severe cuts from contact with spinning
blade.
Do not plug in saw at any time during
assembly.
Plug in saw only when it is to be used.
Remove Sawblade and Guard
1. Tighten carriage lock knob.
2. Loosen guard clamp screw, remove
guard.
3. Motor shaft has left hand threads. Hold
shaft wrench and rotate arbor wrench down
(clockwise).
4. Remove shaft nut, outer collar, sawblade,
and inner collar. Dispose of guard but retain
shaft nut, outer collar sawblade and inner
collar.
Remove Original Table Boards, and
Mounting Supports
NOTE
: All original hardware (except for T-
Nut) will be required for mounting retrofit
parts.
1. Loosen the table clamps and remove the
rear table, spacer table and rip fence.
Discard the rear table and spacer table.
Save the fence, it will be reused.
2. Remove the 1/4-20 x 1" cup point screw
from the T-Nut located in the front table.
Retain this screw for future use.
3. Remove all remaining nut, bolts, and
washers and lift off front table. Discard the
front table.
4. Remove nuts, bolts and washers that
secure the left and right table support chan-
nels. Discard the support channels.
WARNING
This retro fit guard kit required addi-
tional clearance behind fence. New
table boards are being supplied for
this reason.
Blade
Pull Down
to Loosen
Rotation
1/4-20 x 1-3/4"
Pan Hd. Screw
1/4-20 x 1"
Pan Hd. Screw
17/64"
Lockwasher
Front Table
Hex Nut
Lockwasher
1/4-20 x 1"
Cup Point
Set Screw
Table Mounting
Support
Screws
Nut
Lockwasher
7/8" O.D.
Base
Square Hd. Screw
5/16-18 x 3/4
Table Mounting
Support
Flat Washer
Here
Assembly