Filter
Top Products
16
Installing Front Table
1. Set out:
- front table
- tee nut
- 1/4 " U-clip
- 1/4" diam. x 7/8" long cup point set
screw
- four 1/4" diam. x 1" long pan head
screws
- 1/4" dia. x 1-3/4" long pan head screw
- five 17/64" I.D. x 5/8" O.D. flat washers
- four 1/4" lockwashers
- four 1/4" diam. hex nuts
2. Identify top and bottom of table: top has
counterbored holes. Place table bottom
side up on solid surface. Hammer tee nut
into leveling hole. (This hold is not counter-
bored from the top).
3. Snap u-clip onto front edge of base so
hole lines up with hold just to the left of cen-
ter notch.
4. Place table, top side up, on saw so cen-
ter counterbored hole lines up with hole in u-
clip. NOTE:
Table will extend over front edge
of saw frame.
Channel
U-Clip
Tee Nut
(Install from bottom)
Table Mounting Holes
Top of Table
(Counterbored Holes Up
~
Assembly