Filter
Top Products
17
5. Drop a flat washer into each counter-
bored hole.
6. Start 1-3/4" long pan head screw through
center hole and into U-clip, but do not fully
tighten.
7. Start cup point set screw through leveling
hole and into tee nut, but do not fully tighten.
8. Put 1" long pan head screw in each of
four remaining holes and through matching
holes in table supports. On end of each
screw, put lockwasher then nut and tighten
with screwdriver.
Make Front Table Flat
1. Place rear table on its edge, across cen-
ter of front table. Check for gap between sur-
faces.
If there is less than 1/32" gap, tighten cup
point set screw until it touches frame (look
underneath table), then tighten center (1-3/4"
long pan head screw.
If there is more than 1/32" gap, close gap
by raising or lowering center of front table:
to raise center, tighten cup point set screw
against frame;
to lower center, tighten center (1-3/4" long)
pan head screw.
2. When gap is closed, make sure cup point
set screw touches frame (look underneath
table), and center (1-3/4" long) pan head
screw is tightened.
NOTE:
Rip fence scale is no longer correct.
Measure distance between fence and blade
for correct distance when in rip mode.
1
1/4-20 x 1-3/4"
Pan Hd. Screw
1/4-20 x 1"
Pan Hd. Screw
17/64"
Lockwasher
Front Table
Hex Nut
Lockwasher
1/4-20 x 1"
Cup Point
Set Screw
Rear Table
Board
Hold Down
Screw
Leveling
Set Screw
Front Table
Assembly/Adjustments