Filter
Top Products
To Convert to Remote Pressure
Feed
If the material to be sprayed is too
heavy for siphon feed or higher
volume appIication is desired, convert
to the pressure feed set up,
1. Remove the material cup from
lid/gun assembly. NOTE: Stide
release lever to the right, rotate
lid, and remove material cup.
2. Siide yoke, with buiit in socket
feature, over nut. Grip the yoke
and turn to loosen nut, after the
nut is loosened hand turn untit tid
assembly can be removed from
gun.
Typical Pressure Feed Set Up
3. The gun is now ready to be
connected to any pressure feed
tank with a standard 3/8" straight
pipe femate connection. See
paint tank manufacturer's manuat
for correct procedure.
4. See "Operation" Section to tearn
how to use the spray gun.
NOTE: When replacing lid assembly to
gun assembly hand tighten nut and
then slide yoke over nut to tighten
securely.
Regu_ Oil/Water
Extractor
To Air
Supply
Fluid Hose
7-ENG D29783