Filter
Top Products
F_q_,_ USE OF A FACE
MASK IS
RECOMMENDED TO PREVENT IN-
HALATION OF TOXIC MATERIAL.
Before Using Your Spray
Gun
1. Set up spray gun as described
in the "How to Set Up Spray
Gun" paragraph in the
"AssembIy" section of this
manual.
To Use Spray Gun
1. The position of the air cap horns
wilt determine the fan spray
pattern. Loosen air cap and rotate
horns to achieve desired pattern.
Tighten air cap.
Horizontal position
_ Vertical position
2. Turn fluid control knob clockwise
untit it stops, do not force. This
wilt shut off the fluid flow. NOTE:
The fluid or density of "fan spray"
is contretied by fluid control
knob.
3. Turnpattern control knob
counteretockwise untit first thread
is flush with gun body. NOTE: Air
flew is contreIted by pattern con-
trol knob.
_DO NOT turn pattern
control knob or fluid
control knob counter clockwise after
first thread is flush with the gun
body. They are under pressure when
the gun is triggered and could leave
the gun with force.
first thread flush Pattern
Knob
Ruid
4. Turn air valve control knob
clockwise until it stops, do not
force.
5.
regulator.
Air
Valve
Adjust air pressure to 40 psi at
_DO NOT exceed 45
psi.
I_-_ Pressure may vary
according to
viscosity of material used. Maximum
working pressure of gun is 45 psi.
DO NOT EXCEED PRESSURE LIMIT
OF GUN OR ANY OTHER COMPO-
NENT IN SYSTEM!
6. Depress spray gun trigger and
gradually turn the fluid contret
knob counterclockwise until
desired fluid flow is reached.
Tngger gun quickly, one second
on-off to test pattern.
NEVER point spray
gun at self or any
other person. Accidental discharge
of material may result in serious
injury.
To adjust spray pattern and fluid
pressure:
• TO adjust the fluid, turn fluid con-
troi knob counterclockwise to in-
crease or clockwise.
• To adjust the air flow, turn pattern
contret knob counteretockwise to
increase or clockwise to de-
crease.
• To fine tune the air flew, turn air
vatve control knob counterclock-
wise to increase, or clockwise to
decrease.
IMPORTANT: Always clean gun after
each use. See "Maintenance" section
for correct procedure.
9-ENG D29783