Filter
Top Products
DO NOT ATTEMPT
TO UNCLOG (BACK
FLUSH) SPRAY GUN BY SQUEEZING
TRIGGER WHILE HOLDING FINGER
IN FRONT OF FLUID NOZZLE.
Always exercise ex-
treme care when us-
ing any solvent or thinner. Never
clean gun near fire, flame, or any
source of heat or sparks. Properly
dispose of used cleaning materials.
_'_ DO NOT soak entire
spray gun in solvent
or thinner for a long period of time
as this will destroy lubricants and
possibly make motion uneven. NEV+
ER use lye or caustic alkaline solu+
tion for cleaning. Such solutions will
attack aluminum alloy parts of gun.
Cleaning
IMPORTANT: Clean gun immediately
after use. Paint and other materials
dry quickly in the small passages.
1. Turn off air suppiy to gun,
2. Remove the material cup from
lid/gun assembly. NOTE: Slide
release lever to the right, rotate
lid, and remove material cup.
When using the remote pressure
feed method: See manufacturer's
manual for suggested cleaning of
remote cup or tank.
3. Empty matehat from matehat cup
and repiace with a suitable
cieaning soivent (see materia+
container for recommended
solvent).
IMPORTANT: Do not immerse the
gun in solvent, this will cause
damage to the packings.
NOTE: Atways comply with local codes
when disposing of solvents,
6, Remove air cap and immerse in a
suitabte solvent. Use a bristle
brush to clean dried paint and
btow it dry with compressed air.
7, Use a wooden toothpick to clean
smalt ctogged hoies,
IMPORTANT: DO NOT use hard
objects to clean clogged holes.
The smallest amount of damage
may cause irregular spray
pattern.
8, Wipe gun with a solvent soaked
cloth,
IMPORTANT: Make certain air cap
and fluid nozzle are kept clean at all
times.
Lubrication
Lubrication procedures must be ob-
served after thoreughty cteaning the
gun to ensure effective, high quaiity
performance of spray gun,
t, Lubricate working points with
straight mineral oit, or castor oil
2, Pehodica+ly, place a few drops of
oil on tapered sections of fluid
nozzie to ensure easy operation of
air cap,
4. Turn air suppiy on and operate
Replace nozzle set
When changing nozzte set, make sure
the eompiete nozzte set is exchanged.
A set inctudes an air cap, fluid nozzte,
and fluid needle. NOTE: Assemble
5.
trigger untiJ ait mateha+ traces have fluid nozzte before fluid needie.
disappeared and gun is thoreughiy
ctean,
TO prevent corrosion, fi+imaterial
cup with mineral spirits, Turn air
supply on and operate thgger until
att traces of minerat spirits have
disappeared,
11+ ENG [329783