Filter
Top Products
27- ENG
D24910
PROBLEM
CAUSE
CORRECTION
Knocking Noise.
Possible defect in safety
valve.
Operate safety valve manually
by pulling on ring. If valve still
leaks, it should be replaced.
Loose pulley Tighten pulley set screw; see
Parts manual for torque speci-
fications.
Compressor mounting
screws loose
Tighten mounting screws; see
Parts manual for torque speci-
fications.
Loose flywheel Tighten flywheel screw; see
Parts manual for torque speci-
fications.
Loose belt
Loosen wingnut and then
tighten wingnut until it con-
tacts the washer, plus one
turn.
Carbon build-up in pump Have checked by a Trained
Service Technician.
Belt to tight Loosen wingnut and then
tighten wingnut until it con-
tacts the washer, plus one
turn.
Excessive belt
wear
Loose belt.
Tight belt.
Loose pulley.
Have checked by a Trained
Service Technician.
Pulley misalignment.
See Motor Pulley/Flywheel
Alignment paragraph in the
Maintenance section.
Squealing
sound.
Loose belt.
Compressor pump has no
oil.
See Oil-Checking paragraph in
the Maintenace section.
Loosen wingnut and then
tighten wingnut until it con-
tacts the washer, plus one
turn.
Loosen wingnut and then
tighten wingnut until it con-
tacts the washer, plus one
turn.
Loosen wingnut and then
tighten wingnut until it con-
tacts the washer, plus one
turn.
Defective check valve. Remove and clean, or replace.