Filter
Top Products
Using SFP+ Transceiver Modules
An SCv2000/SCv2020 storage system with 16 Gb Fibre Channel storage controllers comes with short
range small-form-factor pluggable (SFP+) transceiver modules.
Figure 32. SFP+ Transceiver Module with a Bail Clasp Latch
The SFP+ transceiver modules are installed into the ports of the SCv2000/SCv2020 storage controller.
Fiber-optic cables are connected from the SFP+ transceiver modules in the SCv2000/SCv2020 to SFP+
transceiver modules in Fibre Channel switches.
Guidelines for Using SFP+ Transceiver Modules
The SCv2000/SCv2020 storage system supports the use of SFP+ transceiver modules for 16 Gb FC
connectivity.
Before installing SFP+ transceiver modules and fiber-optic cables, read the following guidelines:
CAUTION: When handling static-sensitive devices, take precautions to avoid damaging the
product from static electricity.
• Use only Dell supported SFP+ transceiver modules with the SCv2000/SCv2020. Other generic SFP+
transceiver modules are not supported and may not work with the SCv2000/SCv2020.
• The SFP+ transceiver module housing has an integral guide key that is designed to prevent you from
inserting the transceiver module incorrectly.
• Use minimal pressure when inserting an SFP+ transceiver module into an FC port. Forcing the SFP+
transceiver module into a port may damage the transceiver module or the port.
• The SFP+ transceiver module must be installed into a port before you connect the fiber-optic cable.
• The fiber-optic cable must be removed from the SFP+ transceiver module before you remove the
transceiver module from the port.
Install an SFP+ Transceiver Module
Complete the following steps to install an SFP+ transceiver module in a 16 Gb FC storage controller.
About this task
Read the following cautions and information before installing an SFP+ transceiver module.
42
Front-End Cabling