Filter
Top Products
17
Fig. 31
Fig. 32
Fig. 33
Fig. 34
9. With the blade guard (L) Fig. 31, in the raised
position, assemble the saw blade (K) on the saw arbor
and tighten secur
ely with two arbor wrenches
supplied. See section “CHANGING SAW BLADE.”
10. Use a straight edge (E) to check to see if the saw
blade is aligned with the rear of the splitter (G) in Figs. 32
and 33. If alignment is necessary, loosen the bolts (A)
Fig. 33, align splitter (G) with the saw blade, and tighten
two bolts (A).
11. Lower saw blade and install table insert (P) Fig. 34,
in the saw table. IMPORTANT: When installing the table
insert, make certain to hold on to the blade guard (L).
The insert will automatically release the holding action
on the splitter and lower the blade guard when the insert
is installed in the table opening.
L
K
G
G
A
L
P
E