Filter
Top Products
22
Fig. 56
F
B
A
2. Position the fence (B) Fig. 56, along one edge of the
miter gage slot (F) as shown and lock the fence in that
position. The edge of the fence (B) Fig. 56, should line up
parallel to the miter gage slot (F). If an adjustment is
necessary, proceed as follows:
3. Using a square (G) Fig. 57, and a straight edge (H),
check to see if the rip fence (B) is perpendicular to the
saw table and that the rip fence body is level with the
saw table. If a perpendicular adjustment is necessary,
tighten or loosen either of two screws (K) Fig 57 until
the fence is perpendicular and level with the saw table.
4. If a parallel adjustment is necessary, tighten or
loosen either of two screws (D) Fig. 57A until the fence
(B) is parallel to the miter gage slot. NOTE: It will be
necessary to remove the cursor (D) Fig. 58, to make this
adjustment. Readjust the clamping action on the fence;
if necessary, refer to STEP 1. Re-assemble the cursor.
IMPORTANT: THE RIP FENCE MUST BE
PERPENDICULAR TO AND LEVEL WITH THE SAW
TABLE.
5. Depending on the type of saw blade being used, the
cursor (D) Fig. 58, may need adjustment to compensate
for the blade thickness.To adjust the cursor, make a test
cut on a piece of lumber and measure the finished cut,
or you can place the rip fence against the blade as
shown earlier in the manual. If an adjustment is
necessary, loosen two screws (E) Fig. 58, and move the
cursor (D) as necessary and tighten securely.
MAKE SURE RIP FENCE IS SECURELY
LOCKED IN PLACE BEFORE OPERATING SAW.
Fig. 57A
Fig. 58
E
D
E
Fig. 57
G
B
K
K
H
D
B
D