Filter
Top Products
7
FOREWORD
Delta Model 36-465 is a 10" Contractor’s Saw
TM
designed to give high quality performance with maximum depth of cut
3-1/8" (79mm) at 90° and 2-1/8" (54mm) at 45° for clean cutting of stock within the capacities of the saw. Delta Model
36-465 includes; basic machine, sturdy steel stand, integral dust chute, UniRip
TM
T-Square
TM
fence system, patented
Auto-Set
TM
T-Slot miter gage, heavy duty motor, on/off paddle switch, cast iron table, steel table extension wings, see-
thru blade guard with splitter and anti-kickback attachment, convenient up-front blade raising and tilting controls and
10″ blade.
FUNCTIONAL DESCRIPTION
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household
floor paste wax. Fig. 2, illustrates the components of the saw. Fig. 3, illustrates the components of the saw stand. Figs.
3A and 3B, illustrate the components of fence.
NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE
CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED
IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE
ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO
ILLUSTRATE TECHNIQUE ONLY.
FASTENING STAND TO SUPPORTING SURFACE
IMPORTANT: IF, DURING OPERATION, ANY TENDENCY EXISTS FOR THE SAW TO TIP OVER, SLIDE OR WALK
ON THE SUPPORTING SURFACE, THE SAW STAND SHOULD BE SECURED TO THE FLOOR SURFACE. THE
RUBBER FEET OF THE STAND FEATURE HOLES WHICH ALLOW EASY MOUNTING WITHOUT REMOVING THE
SAW FROM THE STAND.