Filter
Top Products
14
ASSEMBLY
(continued)
FIGURE 7
FIGURE 8
FIGURE 9
FENCE GUIDE AND POWER CONTROL BOX
1. Connect the fence guide tube (A) by inserting the smaller
end into the larger end. See Figure 10
2. Attach the fence guide to the front rail using four (for
30" versions) six (for 52" versions) 1/4-20 x 1/2-inch
button head screws and with spring washers
through the holes (B) on the bottom side of
the front rail.
3. Align the two holes in the power
control box bracket with the holes
underneath the front rail (C), located
on the left side of the saw. Secure
the power control box to the front rail
using two1/4-20 x 1/2-inch button
head screws with spring washers.
A
B
C
FIGURE 10
WOOD EXTENSION TABLE
52” rip capacity models only
1. Lay the wood table (A) upside down on floor or
bench.
2. Position legs (B) in corner as shown (fig 7) the
vertical wall of the angle plate on the leg should
be against the end wood wall (C) of the table.
3. Fasten the legs to the table board with (8) #8 x
3/4” self-tapping screws (D).
4. Carefully drill through the holes in the vertical
angle plate holes
and the wood wall of the table
with a ¼ inch drill. Feed the #10-32 X 1 1/4”
screws with #10 flat washers. (E) through the
drilled holes from the
outside, then assemble
nuts onto the screws and tighten.
5. Loosely assemble (3) 5/16-18 x 7/8” screws with
spring washers, flat washers and nuts (F) into
the three holes into the side of the extension
wing as shown. (fig 8)
6. Carefully lower the slotted steel angle table
bracket (G) down onto the screws on the
extension wing. Tighten the screws after the
wood table is leveled with the extensi
on wing.
7. Using the rail alignment gauge (H) adjust the
feet in the legs (I) so the top of the table is at the
proper distance from the rail.
8. Drill ¼ inch holes through the rail holes (J) into
the wood table on the front and back rails. (fig 9)
9. Fasten wood table to rails with ¼-20 X 1 ½” hex
head screws for rear rail and
head screws for front rail, flat washers, and nuts.
A
B
E
D
C
F
G
I
H
J
the
¼-20 X 1 ½” flat